Speakman SEF-2001-8 Guida di Installazione Scaricare il pdf

SEF-2001

SEF-2001-8

EYESAVER

Combination Faucet Spout

Turn off water supplies. Loosen and screw down the Spout Shank Nut (1).

Unscrew Tee Nut (2) from Spout Shank. Remove Shank Nut (1), mounting

hardware, and then remove Spout from counter top.

Using a Tube Cutter, cut the copper tubing between each End Body and

the Tee Assembly. Remove and discard remaining copper tube and

Capture Nuts from End Bodies. Remove COLD supply line from wall

stop and COLD End Body.

Crescent

Wrench

Flat Head

Screwdriver

Keep the EYESAVER

faucet spout looking new by

cleaning it periodically with a soft cloth. Avoid

abrasive cleaners, steel wool, and harsh chemicals

as these will dull the finish and void your warranty.

Cover your drain to prevent loss of parts. Always

wear eye protection.

The supply line for this unit shall provide an

uninterruptible supply of flushing fluid at a minimum

of 30 psi flowing pressure. If shut off valves are

installed in the supply line of the eyewash, provisions

shall be made to prevent unauthorized shut off.

ANSI Z358.1 requires that all emergency equipment

shall be tested weekly to verify proper operation and

inspected annually to assure conformance with

ANSI Z358.1 requirements. Be sure to read

instructions thoroughly before beginning installation.

Do not overtighten any connections or damage may

occur.

92-SEF-2001-R1

Tube

Cutter

Basin

Wrench

1 2 3 4 5 6

Sommario

Pagina 1 - EYESAVER

SEF-2001SEF-2001-8EYESAVERCombination Faucet SpoutTurn off water supplies. Loosen and screw down the Spout Shank Nut (1).Unscrew Tee Nut (2) from Spou

Pagina 2

With Spout fully removed, verify diameter of hole in counter top is a minimum of 1-1/4”. Install mounting studs into base of Spout.From beneath count

Pagina 3

Retrieve supplied hose with a 3/8” fitting on one end, and a 1/2”fitting on the other. Connect 3/8” fitting end to the “F” port of theTee with check v

Pagina 4

Retrieve the two (2) remaining supplied hoses. Take the first hose andconnect one end to the “E” port of the Supply Tee with no checkvalves. Connect t

Pagina 5 - Eyewash Flow Data

psi bar gpm L/min in. cm.30 2.07 2.14 8.1 12 30.540 2.76 2.25 8.5 13 33.050 3.45 2.49 9.4 15 38.160 4.14 2.70 10.2 18 45.770 4.83 2.95 11.2 21 53.380

Pagina 6 - ROUGH-IN MEASUREMENTS

ROUGH-IN MEASUREMENTS 4-1/2" 19” (SEF-2001)17” (SEF-2001-8) (2 HOSES) 2-5/8" 2" MAX. DECK HEIGHT 2-1/4" 8" 12° 4-7/8&

Commenti su questo manuale

Nessun commento

Speakman SEF-2001-8 Guida di Installazione

Navigare online o scaricare Guida di Installazione per Rubinetti Speakman SEF-2001-8. Speakman SEF-2001-8 Installation Guide Manuale Utente

Sommario

Commenti su questo manuale